Enfora MT2500

Anschlüsse

Der Stecker ist Molex Bestellnummer 43025-1600 und die korrekten Kontakte dazu sind Molex Bestellnummer 43030-0008.

Pin	Name	Description	-	1	Ear (-)	Ear Phone - Note: This is an output only that is connected directly to the modem. Input voltages should not be applied.	2	Ear(+)	Ear Phone + Note: This is an output only that is connected directly to the modem. Input voltages should not be applied.	3 1-Wire 1-Wire® Interface Note: Maximum voltage on this pin is 3.3 VDC 4 ADC In #2 Analog-to-Digital Input, 0 – 32 VDC 5 ADC In #1 Analog-to-Digital Input, 0 – 16 VDC 6 Ground System Ground 7 Ground System Ground; Connector has longer pin for MFBL. 8 Digital Digital Input #2 (GPI9) Input #2 9 Digital Digital Input #1 (GPI1) Input #1 10 RS-232 CTS RS-232 CTS Out Note: This is an output only. Input voltages should not be applied. 11 Ignition Vehicle Ignition Sense Sense 12 MIC (-) Microphone - Note: Although this signal is AC (capacitively) coupled to the modem, there is a 1K Ohm resistor to ground with a power rating of 0.0625 W. This limits max- imum input voltage to <7.9VDC. Designed for audio only, any other signals or voltages may damage the device. 13 MIC (+) Microphone + Note: Although this signal is AC (capacitively) coupled to the modem, the MIC- BIAS output from the modem has a 330 Ohm to 1K Ohm voltage divider with a 10 uF, 6.3 V capacitor connected between the two resistors and to ground. Assuming a 2.6 V MICBIAS output, this limits the maximum voltage that may be applied to the MIC+ input to approximately <15 VDC so that the voltage rat- ing of the capacitor is not exceeded. 14 Digital Output, High-Current Sink, Low-Current Source, Latched (GPO2) - 12 - Output 1 15 Digital Output, High-Current Sink, Low-Current Source, Latched (GPO5) Output 2 16 Digital Output, High-Current Sink, Latched (GPO3) Output 3 17 Power In Vehicle Power from 12 or 24 V Vehicles; 18 Power In Vehicle Power from 12 or 24 V Vehicles; 19 Digital Digital Input #3 (GPI10) Input #3 20 RS-232 RTS RS-232 RTS In Note: -25 VDC to 25 VDC 21 RS-232 TX RS-232 TX In Note: -25 VDC to 25 VDC 22 RS-232 RX RS-232 RX Out Note: This is an output only. Input voltages should not be applied. Anleitungen File:Mt2500 quick start guide.pdf File:UK ENF MT 4000 User Guide.pdf File:AT-Commands.pdf File:Programmingenfora.pdf